Landscape lighting transformer – Disable landscape lighting transformer to stop the transformer from drawing housekeeping when the landscape lights no longer work or when removing the lights from your landscape architecture. Turning on the landscape lighting the photocell allows you to activate the lighting manually. Or also set the timer on the preset for preset at times. It also allows you manual control when the photo cell is no longer working properly. Landscape lighting transformer and photo cells use your landscape light, allowing the light to progress from dusk to dawn or sometimes you choose by using the built-in timer. Instructions to disable landscape lighting transformer & photocells is, starting by disconnect the transformer from the power supply.
Disconnect landscape lighting transformer that plug into the wall. Second, place black electric tape over the “eye” photo camera to cause landscape lights to come on to find the circuit that supplies power to a wired landscaping transformer. Switch off the switches inside the power box until the light is no longer burning. Place the power strip over the switch in “Off” mode to keep other people in your home from turning it on again. Third, loosen the pole screws at the bottom or back of the landscape lighting transformer that connects the low voltage cables to the transformer. Pull the cables from underneath the transformer connection screws. Fourth, loosen the pole screws at the bottom of the rear of the transformer that connects the photocell to the transformer.
12 Photos Gallery of: To Disable Landscape Lighting Transformer & Photocells
Pull the three wires from below the pole screws on the transformer to connect the photoelectric cell. Fifth, disconnect the power to the landscape lighting transformer by connecting the transformer or turning off the switch. Unscrew hard-coded photocell from the body of the transformer. Last, pull the photocell from the body of the transformer to expose the wires. Twist the contactors that hold the two wires from the transformer to the two wires from the photocell. Twist one of the wire connections back on the two cables from the transformer to reconnect the circuit. Push the wires into the transformer and twist a weather plug in the opening.More reader came from this term: outdoor lighting power supply, landscape transformer, landscape lighting transformer, landscape light transformer, landscape lighting photocell, outdoor lighting photocell, transformer bedroom ideas, landscape lighting power supply, how to disable outdoor transformer, outdoor lighting transformer disable sensor